Code-3 V-Con Siren Manuale Utente

INSTALLATION & OPERATION MANUAL3600 SERIES SIREN Contents:Introduction ...2Standard Featur

10Lighting Controls (For L4 Models Only)WARNING LIGHTS 3-LEVEL PROGRESSIVE SLIDE SWITCH:POSITION 1 - Supplies power to Lighting Level 1. Illuminates

11CABLE AND RECONNECT AS SHOWN ABOVE.6 WIRE, SHIELDED CABLE (COMMON MIC ONLY)RRB ADJUSTMENTLIGHT BAR CABLE GROUNDS-120 A.CIRCUITS-62-WAY RADIOCIRCUIT

12Parts ListRef No. Description Part No. Qty.1 MS, #4-40 x 3/8", FLAT HD PHIL, BLK OXIDE T01101 22 MS, #4-40 X 1/4, RND HD, BLK OXIDE

13EXPLODED VIEW1122234555666789999101025111111 11111213141516171818191920212122222222242626272728293031323323

14OptionsSirenLock TM (L4 and L6 Models Only)- An interlock circuit between the siren and the light control circuits that permits automatic siren tone

15Auxiliary Controls A, B, C, D switches A,B, C & D switches are latchin

16A. REPLACE MICROPHONEB. PLUG MICROPHONE IN SECURELYC. CHECK WIRINGD. CALL PSE FOR LIST OF ADAPTABLE MICROPHONESPROBLEMPROBABLE CAUSEREMEDYNO SIREN

17A. SUPPLY FUSE OPENB. SIREN TERMINAL NEGATIVE NOT GROUNDEDA. REPLACE FUSE.B. RECONNECT TERMINAL NEGATIVE TO GROUND.PROBLEMPROBABLE CAUSEREMEDYA. MAX

18NOTES

19NOTES

2IntroductionThe 3600 series electronic siren has been designed to meet the needs of all emergency vehicles. This series of sirens incorporates the po

Revision 0, 07/10 - Instruction Book Part No. T55363 ©2010 Public Safety Equipment, Inc. Printed in USACode 3 is a registered trademark of Code 3, Inc

33672L4 - Same as 3672 plus Light Controls3692L4 - Same as 3692 plus Light Controls 3696PL - Same as 3696P plus Light Controls3694- Same feat

4Unpacking & Pre-installationAfter unpacking your 3690 series siren, carefully inspect the unit and associated parts for any damage that may have

5Terminal Block Connections 8 Position Terminal Block- ( see wiring diagram page 16 )S1 - +12VDC, connect to a positive +12 volt DC source. It is r

6Power Distribution Connections ("L4" Models)A #8 stud is provided on the rear of the unit and is intended for use ONLY as a convenient gro

7T7 - +12VDC - Connect to the positive terminal of the battery with 30 Amp circuit protection. Locate the fuse or circuit breaker at the battery and

8Conguration SwitchesReferring to DETAIL B below, gently set the Hit & Go, LightAlert and SirenLock set-up switches to the desired posi-tion. Th

9"Wail" and "Yelp" tones are in some cases (such as in the state of California) the only recognized siren tones for calling for th