Code-3 PSE LED F12 12 Output Flashers Manuale Utente Scaricare il pdf (Pagina 4)

Flash - Pattern Programming

A. Lightbar Version:

The desired flash pattern for any of the progressive operation modes 1, 2, & 3 can be programmed as follows:

1. Power one Mode-control wire at a time. Example: If the Mode1 flash pattern is to be programmed,

connect +12V to only the Mode1 control wire.

2. Connect the yellow (PGM) wire momentarily to +12V and release it to select the next available

pattern. Repeat until the desired pattern is selected. (refer to page 1 for available flash patterns)

3. Repeat steps 1 & 2 above for all three Mode-control wires one at a time. Note: Mode 3 overrides

Mode 2 and Mode 2 overrides Mode 1.

B. Remote Version:

1. Enable the blue and/or green wires first to select regular operation pattern.

2. Apply 10-16 VDC momentarily to the yellow wire, repeat until desired pattern is selected.

3. Repeat steps 1 & 2 enabling the white wire in addition to the blue and/or the green wire to select

the desired Interclear® mode flash pattern.

4. Tape or ground the yellow wire when programming is complete. Note: Interclear® Mode

overrides regular operation mode.

Figure5

18 AWG RED/BLACK

WIRE DESIGNATION:

18 AWG BROWN

18 AWG RED

18 AWG WHITE

18 AWG YELLOW

18 AWG GREEN

18 AWG BLUE

2. Blue: 10-16V Group A Enable

3. Yellow: 10-16V Flash Pattern PGM (Momentary)

4. White: 10-16V Interclear® Enable

5. Brown: Photocell Input

7. Black: Photocell Ground

8. Green: 10-16V Group B & C Enable

10.Red/Blk: Not Used

11.Red: Not Used

18 AWG BLACK

Figure6

Remote Version Wiring Diagram

1 2 3 4 5 6 7 8

Nessun commento

Code-3 PSE LED F12 12 Output Flashers Manuale Utente Pagina 4