Code-3 DeckBlaster Manuale Utente

INSTALLATION&OPERATIONMANUALSERIES800Read all instructions and warnings before installing and using.INSTALLER: This manual must be delivered to

Code 3 & Deckblaster are registered trademarks of Code 3, Inc. a subsidiary of Public Safety Equipment, Inc.3M and Scotchmate are registered tra

IntroductionThe DeckBlaster® product line represents the latest advances in low cost directional dash and deck-mount-able warning lights. Designed fo

Permanent MountingAttach the basic mounting bracket to the bottom of the unit using the two screws supplied in the mountingkit as shown in Fig. 1. Po

!WARNING!NOTE: All DeckBlaster units are reverse polarity protected. No damage will result from incorrectconnection of the inputs if within the speci

Disassembly/AssemblyTurn the unit upside down, remove the four screws holding the case together and remove the bottom casehalf by lifting upward. To

Halogen Lamp/Flashtube Replacement for non-remote modelsRemove the circuit board/reflector assembly. Using a needle-nose pliers,straighten the leads

7Unit does not flash. No power connected to unit. Connect unit to power.Blown fuse. (External) Check user-installed fuse.Replace with properly sized f

15786423109Deckblaster Parts List (Non-Remote Models)Ref No. Description Part No. Qty.1 Upper Case Half T06570 12 Circuit Board - Basic Halogen S65175

9Basic Strobe (805) 2.50" 5.65" 2.5 A 80 9 JBasic Halogen 2.50" 5.65" 1.25 A 110 27 W (800)Switchable Halogen 2.50" 5.