Code-3 PSE460 Remote Strobe Power Supply Manuale Utente

INSTALLATION& OPERATIONMANUALPSE460TMREMOTE STROBEPOWER SUPPLYREMOTE STROBEPOWER SUPPLYContents:Introduction ...

10MULTIPLE FLASH MODESBy selecting the proper switching, any number of flash modes can be used.Example: Triple Flash with Five FlashFIGURE 7LOW CURREN

MaintenanceThe PSE460 Remote Strobe Power Supply has been designed to provide trouble free service. In case ofdifficulty , refer to the Troubleshootin

WARRANTYThis product was tested and found to be operational at the time of manufacture.Provided this product is installed and operated in accordance w

IntroductionThe PSE460 Series Remote Power Supply represents the latest in state-of-the-art strobe warning technology.The latest in MOSFET technology

The use of this or any warning device does not insure that all drivers can or will observe orreact to an emergency warning signal. Never take the rig

Installation and MountingMOUNTING THE MODEL PSE460 STROBE LIGHT POWER SUPPLYTo obtain maximum performance and durability the Model PSE460 strobe light

5RED WIRE - (ANODE) POSITION 1WHITE WIRE - (TRIGGER) POSITION 3STRIP INSULATION TO EXPOSEBARE WIRE AS SHOWNFIGURE 3AMP 3 PIN SOCKET HOUSINGPN 1-480303

FLASH CONTROL HARNESS ASSEMBLYThe Flash Control wire harness is to be connected to the 4 position socket connector on the PSE460 strobepower supply.

Flash Control Switching OptionsTo select any one of eight different FLASH MODES , simply connect the White, Orange, Yellow and Brownwires to a switch

The following diagrams show some of the wiring configurations possible for various flash modes. All fusesshown are to be customer supplied, and recomm

9SELECTIVE SWITCHING OF OUTLETS 1 AND 4 (only)OROUTLETS 2 AND 3 (only) IN HIGH POWERCYCLE FLASH MODESTANDARD DOUBLE FLASH MODE4 OUTLETS ON-OFF SWITCHI